Preheaters - Element & Pad Type
encapsulated or confined element oil pr eheater positively puts an
end to any concerns of boiling oil or the separation of suspended
minerals, paraffins and other oil additives. STEF’s design isolates
the element itself from direct oil contact within a 3/4" x 4"
sealed stainless steel housing containing a highly heat conductive
media. Designed primarily for dry sump tank or wet sump oil pan (room
permitting) installation, this new design, when plugged into any 110/120
volt shop or portable generator source, will increase 5 quarts of
engine oil 50° to 60°F (depending on viscosity and ambient
temperature) in 15 minutes and that same 5 quarts may reach 180°F
in 45 minutes. For larger volumes of oil the time increase is less
than proportional to volume. STEF’S unique design also incorporates
a -12AN thread O-ring and weld nut allowing heater removal for draining
and routine cleaning. A three foot power cord is included.
self-adhesive oil preheater pads are designed for the racer where
weld-in element style preheater location is prohibitive. These 5"
x 7" self-adhesive, nylon reinforced, high temperature silicon
jacketed pads will adhere to any clean, flat or radius surface and
offer the many benefits of oil preheating to the wet sump racer, automatic
transmission racer as well as dry sump tank applications. When the
included 6 foot power cord is plugged into any 110/120 volt shop or
portable generator source this pad shows its merit. Engine oil temperature
increases of 60° to 70°F (depending on viscosity and ambient
temperature) may be achieved when 5 quarts of oil are exposed for
15 minutes. 200°F oil temperatures can be reached using the same
5 quarts in volume in less than 45 minutes. For larger volumes of
oil the time increases less than proportionately.
Sump Tank/500 Watt-Aluminum Bung
Heater-Dry Sump Tank/Oil Pan 4" Element-Aluminum
Sump Tank/Oil Pan 4" Element-Steel
Sump Tank/500 Watt-Steel Bung
of Element style Pre-heater in your oil pan
Oil Pre-heater Pad w/ 6ft cord.